Control IPCs Model APAX-5040 APAX-5045 APAX-5046/ APAX-5046SO APAX-5060 APAX-5080 Description 24-ch DI module 24-ch DI/O module 24-ch/20-ch DO module 12-ch relay module 4/8-ch counter module General Dimensions (W x H x D) 30 x 139 x 100 mm Power Consumption 2 W @ 24 VDC (typical) 2.5 W @ 24 VDC (typical) 2.5 W @ 24 VDC (typical) 2 W @ 24 VDC (typical) 2.5 W @ 24 VDC (typical) Status Display LED per channel On: Logic level 1 Off: Logic level 0 Digital Input Channels 24 12 - - 4 (Sink) Input Voltage Rated Value: 24 VDC, For "0" signal: -5 ~ 5 VDC, For "1" signal: 15 ~ 30 VDC and -15 ~ 30 VDC Rated Value: 24 VDC, For "0" signal: -5 ~ 5 VDC, For "1" signal: 15 ~ 30 VDC and -15 ~ 30 VDC - - For "0" signal: 0 ~ 3 VDC, For "1" signal: 10 ~ 30 VDC Type Sink or Source Load Sink or Source Load - - - Digital Output Channels - 12 (Sink) 24 (Sink) - 4 (Sink) Voltage Range - 8 ~ 35 VDC 8 ~ 35 VDC - 8 ~ 35 VDC Rated Current Output - 0.5 A (per channel, at signal "1") 0.5 A (per channel, at signal "1") - 0.5 A (per channel) Relay Output Channels - - - 12 - Counter/ Frequency Input Channels and Mode - - - - 8 (up and frequency mode), 4 (Pulse/ Direction, Up/Down, A/B phase mode) Counting Range - - - - 32-bit + 1-bit overflow Minimum Pulse Width - - - - 1 µs for High Freq. mode and other modes Counter Frequency - - - - 0.1 Hz ~ 10 Hz for Low Freq. mode and Wave Width mode, 10 Hz ~ 1M Hz for High Freq. mode and other modes Input Voltage - - - - For "0" signal: 0 ~ 3 VDC, for "1" signal: 10 ~ 30 VDC Environment Operating Temperature -10 ~ 60°C (when mounted vertically) Storage Temperature -40 ~ 70°C Relative Humidity 5 ~ 95% (non-condensing) Page online online 12-22 12-23 12-23 APAX Series Selection Guide APAX Digital I/O Module Chapter 12 Table of Contents Table of Contents