10-41 www.mo xa .c o m NPort® 5600-8-DT Lite Series Serial-to-Ethernet Device Servers > 10 Serial Connectivity NPort® 5600-8-DT Lite Series Overview 8-port RS-232/422/485 serial device servers NPort® 5600-8-DTL device servers can conveniently and transparently connect 8 serial devices to an Ethernet network, allowing you to network your existing serial devices with basic configurations. You can both centralize management of your serial devices and distribute management hosts over the network. The NPort® 5600-8-DTL device servers have a smaller form factor than our 19-inch models, making them a great choice for applications that need additional serial ports when mounting rails are not available. Convenient Design for RS-485 Applications The NPort® 5650-8-DTL device servers support selectable 1 kΩ and 150 kΩ pull high/low resistors and a 120 Ω terminator. In some critical environments, termination resistors may be needed to prevent the reflection of serial signals. When using termination resistors, it is also important to set the pull high/low resistors correctly so that the electrical signal is not corrupted. Since no set of resistor values is universally compatible with all environments, NPort® 5600-8-DTL device servers use DIP switches to allow users to adjust termination and pull high/low resistor values manually for each serial port. LED Indicators to Ease Your Maintenance Tasks The System LED, Serial Tx/Rx LEDs, and Ethernet LEDs (located on the RJ45 connector) provide a great tool for basic maintenance tasks and help engineers analyze problems in the field. The NPort® 5600’s LEDs not only indicate current system and network status, but they also help field engineers monitor the status of attached serial devices. › ›8 serial ports supporting RS-232/422/485 › ›Compact desktop design › ›10/100M auto-sensing Ethernet › ›Configure via Telnet/Web/Windows utility › ›Socket modes: TCP server/TCP client/UDP/Real COM › ›SNMP MIB-II for network management Appearance Serial ports NPort® 5610-8-DTL: DB9, RS-232 NPort® 5650-8-DTL: DB9, RS-232/422/485 Reset button LED indicators Ethernet RJ45 10/100 Mbps Power input Power Jack (12 to 48 VDC) Specifications Ethernet Interface Number of Ports: 1 Speed: 10/100 Mbps, auto MDI/MDIX Connector: 8-pin RJ45 Magnetic Isolation Protection: 1.5 kV built-in Serial Interface Number of Ports: 8 Serial Standards: NPort 5610-8-DTL: RS-232 NPort 5650-8-DTL/5650I-8-DTL: RS-232/422/485 Connector: DB9 male Serial Line Protection: 15 kV ESD protection for all signals 2 kV isolation protection (NPort 5650I-8-DTL only) RS-485 Data Direction Control: ADDC® (Automatic Data Direction Control) Pull High/Low Resistor for RS-485: 1 kΩ, 150 kΩ Terminator for RS-485: 120 Ω Serial Communication Parameters Data Bits: 5, 6, 7, 8 Stop Bits: 1, 1.5, 2 Parity: None, Even, Odd, Space, Mark Flow Control: DSR/DTR and RTS/CTS (RS-232 only), XON/XOFF Baudrate: 50 bps to 921.6 kbps Serial Signals RS-232: TxD, RxD, RTS, CTS, DTR, DSR, DCD, GND RS-422: Tx+, Tx-, Rx+, Rx-, GND RS-485-4w: Tx+, Tx-, Rx+, Rx-, GND RS-485-2w: Data+, Data-, GND