11-11 www.mo xa .c o m Embedded Device Servers > 11 MiiNePort E3 Series Serial Connectivity MiiNePort E3 Series The MiiNe was created to provide manufacturers with a competitive embedded serial-to-Ethernet solution. The MiiNePort E3, which uses the MiiNe for its SoC, is a compact embedded device server that has the lowest power consumption among similar products. The MiiNe has the following features: • Designed for serial-to-Ethernet applications • Uses an ARM core • Uses Moxa’s own advanced UART technology • 2 MB Flash and 4 MB SDRAM memory built in 10/100 Mbps embedded serial device servers Moxa’s MiiNePort E3 series embedded device servers are designed for manufacturers who want to add sophisticated network connectivity to their serial devices with minimal integration effort. The MiiNePort E3 is empowered by the MiiNe, Moxa’s second generation SoC, which supports 10/100 Mbps Ethernet, up to 921.6 kbps serial baudrate, a versatile selection of ready-to-use operation modes, and requires only a small amount of power. By using Moxa’s innovative NetEZ technology, the MiiNePort E3 can be used to convert any device with a standard serial interface to an Ethernet-enabled device in no time. In addition, the MiiNePort E3 is a compact embedded device server with an RJ45 connector, making it easy to fit into virtually any existing serial device. MOXA MiiNe RJ45 Connector 8 Pin Connector GPIO I2 C Timer MAC Ethernet SDRAM (4MB) FLASH (2MB) POWER System Watchdog Timer PHY UART SPI RJ45 Connector 8-Pin Connector GPIO I2 C Timer MAC Ethernet SDRAM (4MB) FLASH (2MB) POWER System Watchdog Timer PHY UART SPI Overview The MiiNe—Moxa’s 2nd Generation SoC Specifications › ›IEEE 802.3af compliant PoE pass-through › ›Use Moxa’s high quality and reliable second generation MiiNe SoC › ›Versatile choice of operation modes fulfill specific application requirements › ›Green design with extremely low power consumption › ›MiiNePort NetEZ Technology makes integration incredibly easy › ›Highly compact embedded device module Form Factor Type: Pin header module Dimensions: 35 x 52.5 x 18 mm (1.38 x 2.07 x 0.71 in) Weight: 12 g (0.03 lb) System Information CPU: 32-bit ARM Core RAM: 4 MB built in Flash: 2 MB built in Ethernet Interface Number of Ports: 1 Speed: 10/100 Mbps, auto MDI/MDIX Connector: RJ45 (magnetic) Magnetic Isolation Protection: 1.5 kV built-in LEDs: 10BASE-T & 100BASE-TX Link Activity PoE Pass-through: 802.3af compliant Serial Interface Number of Ports: 1 Transmission Format: Standard TTL Serial Communication Parameters Data Bits: 5, 6, 7, 8 Stop Bits: 1, 1.5, 2 Parity: None, Even, Odd, Space, Mark Flow Control: RTS/CTS, DTR/DSR, XON/XOFF Baudrate: MiiNePort E3: 50 bps to 230.4 kbps MiiNePort E3-H: 50 bps to 921.6 kbps Note: Non-standard baudrates supported Serial Signals TTL: TxD, RxD, RTS, CTS, DTR, DSR, DCD, RST (reset circuit), GND