17-7 www.mo xa .c o m Remote I/O > ioLogik E1200 Series Remote Automation 17 ioLogik E1212 Specifications ioLogik E1211 Specifications ioLogik E1210 Specifications Inputs and Outputs Digital Inputs: 16 channels Isolation: 3k VDC or 2k Vrms Digital Input Sensor Type: Wet Contact (NPN or PNP), Dry Contact I/O Mode: DI or Event Counter Dry Contact: • On: short to GND • Off: open Inputs and Outputs Digital Outputs: 16 channels Isolation: 3k VDC or 2k Vrms Digital Output Type: Sink I/O Mode: DO or Pulse Output Pulse Output Frequency: 500 Hz Over-Voltage Protection: 45 VDC Inputs and Outputs Digital Inputs: 8 channels Configurable DIOs (by jumper): 8 channels Isolation: 3k VDC or 2k Vrms Digital Input Sensor Type: Wet Contact (NPN or PNP), Dry Contact I/O Mode: DI or Event Counter Dry Contact: • On: short to GND • Off: open Wet Contact (DI to COM): • On: 10 to 30 VDC • Off: 0 to 3 VDC Common Type: 8 points per COM Counter Frequency: 250 Hz Digital Filtering Time Interval: Software Configurable Wet Contact (DI to COM): • On: 10 to 30 VDC • Off: 0 to 3 VDC Common Type: 8 points per COM Counter Frequency: 250 Hz Digital Filtering Time Interval: Software configurable Power Requirements Input Voltage: 12 to 36 VDC Input Current: 110 mA @ 24 VDC MTBF (mean time between failures) Time: 671,345 hrs Standard: Telcordia SR332 Over-Current Protection: 2.6 A (4 channels @ 650 mA) Over-Temperature Shutdown: 175°C (typical), 150°C (min.) Current Rating: 200 mA per channel Power Requirements Input Voltage: 12 to 36 VDC Input Current: 200 mA @ 24 VDC MTBF (mean time between failures) Time: 923,027 hrs Standard: Telcordia SR332 Digital Output Type: Sink I/O Mode: DO or Pulse Output Pulse Output Frequency: 500 Hz Over-Voltage Protection: 45 VDC Over-Current Protection: 2.6 A (4 channels @ 650 mA) Over-Temperature Shutdown: 175°C (typical), 150°C (min.) Current Rating: 200 mA per channel Power Requirements Input Voltage: 12 to 36 VDC Input Current: 155 mA @ 24 VDC MTBF (mean time between failures) Time: 561,930 hrs Standard: Telcordia SR332 For Modbus devices that are controlled and detected by fixed addresses, users need to spend a vast amount of time researching and verifying initial configurations. Users need to locate each device’s networking details, such as I/O channels or vendor-defined addresses, to enable the initial or start address of a SCADA system or PLC. The ioLogik E1200, with user-definable Modbus/TCP addressing, offers greater flexibility, and setup is easy. Instead of worrying about individual devices, users simply configure the function and address map to fit their needs. User-Definable Modbus/TCP Addressing for Painless Upgrading of Existing Systems